Mold testing in Cartersville, GA

Mold testing sends air or surface samples from a house to an independent lab, and the findings come back in a written report. We test for buyers, sellers and agents in Cartersville and across Northwest Georgia, with a home inspection or on its own, and we don't do mold removal.

Crawl space with a dirt floor and stacked brick and block piers under a beam

We offer two kinds of mold testing. An air test compares the air in the rooms you're worried about with the air outside, and a swab test checks a single spot, such as a ceiling stain. Both kinds of samples go overnight to an independent lab, and each test ends with a written report.

You can add either one to a home buyer inspection or a pre-listing inspection, or book it on its own. Our home inspection prices webpage lists what each test costs.

How do you test a home for mold?

Mold detection starts with what you've noticed. If a house smells musty and you can't find the source, an air test fits. If you're looking at a stain and wondering what it is, a swab fits.

Mold air testing against an outdoor sample

Every air test includes one outdoor sample as the baseline, plus indoor samples from each area of concern. The lab analyzes them all, and the written report compares each indoor area with the outdoor sample and gives each one an elevation level.

The EPA says to suspect hidden mold when a house smells moldy but you can't see the source, and its guide lists places it hides:

  • the back side of drywall, wallpaper or paneling;
  • the upper side of ceiling tiles;
  • the underside of carpets and pads;
  • inside walls around leaking or sweating pipes;
  • inside ductwork.

Mold swab testing for one spot

A swab test checks one area, such as a bathroom wall, a ceiling stain or the wall around a window. We swab it, the sample goes to the lab overnight, and the written report shows whether mold growth is present in that sample.

The EPA says that in most cases, if mold growth is visible, sampling is unnecessary. A swab helps most when you can't tell whether a stain is mold.

What mold testing can and can't tell you

A test answers one question: what the lab found in the samples that were taken. Federal agencies add two cautions:

  • No EPA or other federal limits exist for mold or mold spores, the EPA notes, so a sample can't show whether a house meets a federal standard.
  • NIOSH, the CDC's institute for workplace safety and health, doesn't recommend routine air sampling for mold. It says short-term air samples, especially ones that find no mold, may not represent what's actually in the air people breathe.

When you book, tell us what you've noticed and where, whether that's a smell, a stain or a past leak.

What to do when mold testing finds mold

Fix the moisture and clean up the mold. The EPA says a homeowner can usually handle an area of less than about 10 square feet. For more than that, or after a lot of water damage, the EPA points to its remediation guidance, and if you hire a contractor, it says to choose one with experience cleaning up mold.

Cleanup is a mold remediation company's work, and we don't do it.

If you're buying, InterNACHI's FAQ for buyers says that when an inspection turns up evidence of mold, you should find out how the problem can be addressed and whether you can negotiate the cost with the seller. Your agent can help with that part.

Mold testing in Rome, Cartersville and Northwest Georgia

The CDC says mold grows where there's moisture, such as around leaks in roofs, windows or pipes, or where there's been a flood. The EPA's advice on moisture is to keep indoor humidity below 60 percent, ideally between 30 and 50, dry wet materials within 24 to 48 hours of a leak, and keep the ground sloping away from the foundation. Our crawl space vapor barrier guide covers what a home inspector checks under a house.

We do mold testing in Rome, Cartersville and across Bartow County, and in Calhoun, Dalton, Rockmart, Dallas, Acworth, Woodstock and Canton. Our guide to home inspection cost in Georgia compares national price ranges for mold testing.

Mold testing questions, answered

Is your mold testing independent?

Yes. The samples go to an independent lab, and since we don't sell mold removal, we have no stake in what the lab finds.

Can you test for black mold?

We test for mold of any kind, not black mold alone. The CDC describes Stachybotrys chartarum as a greenish-black mold, and it says you don't need to know which type is growing: Stachybotrys or any other mold found in a building should be removed.

Is mold testing part of a home inspection?

No. InterNACHI's standards of practice don't require a home inspector to determine whether mold is present, so mold testing is a separate test. You can add it to a home inspection or book it on its own.

How much does mold testing cost?

Air testing is priced per sample with a three-sample minimum, and swab testing per swab, with lab analysis and overnight shipping included. Our home inspection prices webpage lists both, and our guide to home inspection cost in Georgia shows national price ranges.

Ready to book your home inspection?

Send a request with your town and deadline, pick a time yourself online, or call and we'll set a time.

Call Request an inspection